Build a Pine Bathroom Vanities

0

Pine bathroom vanities – Putting together a pine vanity with a simple cover is a single construction project where you can create an attractive finished project and begin learning process that goes into making a cupboard. A pine vanity only requires the construction of a hinged door and no drawers, so it’s a good place to start to learn cabinet making skills. Build base for your freezer then cut the boards to the base. Now cut the front and rear boards. Put the base together. First screw together four long pieces. The base will still be flexible on this point, but when you put the four belts in the corners, so the base must be rigid. Again, countersink bit, drill a pilot hole and insert the screws.

Cut two pieces of plywood. Cut the boards to the bottom of the cabinet pine bathroom vanities. Glue the boards to the plywood, and screw them from the bottom by means of 1-inch wood screws. No need to countersink here. Build back piece (wall) of the cabinet. Add the nine pieces on a flat surface, so that everything is perfectly square, and attach the strip near the top, so that the thickness of the plywood is the same as the distance between the band and the top of the back. Make the two side pieces. Put the two side pieces together using bands at the top as a temporary bandage. Keep the distance between the band and the top is the same as you did for the back.

Sit back and two side pieces on top of the base pine bathroom vanities and temporary attach with screws. Make the front with four full width 1 X 4 pieces clear pine. Place the sheet of plywood on top, and then put the front piece should turn right into plywood. Ensure that all four sides are screwed together tightly. Build the door to the opening in the front. Add the clear pine to the top and cut a whole for the sink. An alternative method would be to cut the hole in the plywood into the sink and then add the pieces of clear pine.

Comments are closed.