Installing Freestanding Bathroom Vanities

0

Freestanding bathroom vanities – Bathroom design has gone through revolutionary changes during the last 20 years takes place once utilitarian and expanded its options to make it a much more inviting space. Today’s bathrooms are enlarged and detailed with features like steam showers, saunas, whirlpools and decorative vanity patterns. A popular vanity design suite is a freestanding antique vanity, change the once-simple storage cabinet into an attractive piece of furniture. Installation is a simple procedure and quickly transforms your bathing environment. Confirm that the preliminary hot and cold water valves and plumbing sewer line has been installed properly for the new vanity cabinets.

Freestanding bathroom vanities, measure and mark the center line on the desired vanity cabinet spot on the wall then extend the line to the floor, just above the new freestanding vanity cabinet top surface height. Place new freestanding vanity cabinet to which you can access at the rear of the cabinet and the wall connections for the plumbing. Measure the center line of both the water supply valves and drain line plastic projects from the wall from the floor and from the center line. Transferring these center line measurements to the back of the new independent vanity cabinet. Scribe a circle about 3 inches in diameter for each water supply valves and a circle about 4 inches in diameter sewer line by means of a drawing compass.

Cut openings selected for plumbing connections on the back of the vanity cabinet with a jigsaw. Place the new vanity cabinet against the wall, to make certain the water supply valve and drain line is centered in the holes. Level of new freestanding bathroom vanities cabinet with a builder’s level and adjusts the bone screws needed. Secure the back of the stand alone vanity cabinet on the wall with the 2 1/2-inch wood screws and spacer block as needed. Note: usually the wall connections and blocks held at least 6 to 8 inches from the vertical edge of the cabinet so that the block is not visible. Lay out the new vanity sink cut out the template provided and the manufacturer’s instructions. Cut a hole for the sink in the vanity cabinet top with a hacksaw. The installation of the ancient free-standing vanity cabinet is now complete and ready for the sink installation and final plumbing connections.

Comments are closed.