Installing Wall Mounted Bathroom Vanities

0

Wall mounted bathroom vanities – Before installing a 72 inch wide bathroom vanity or vanity of any size, you must mark the area where the vanity will be placed to ensure proper installation in advance. Think about the placement of fittings in the room, including air vents, which can draw on installing vanity. You must anchor the vanity to the wall studs as they provide the anchor that will keep the vanity of shifting later. Measure the height of vanity, and then draw the outline of the vanity to the wall where you want to install it. Measure the depth of the vanity and mark the measurement on the bathroom floor with masking tape. Here you can see if the vanity will block everything else in the bathroom, such as roads or other sanitary ware, so you can change the vanity position before installing it.

Wall mounted bathroom vanities, locate the studs in the wall with a stud finder, inside the vanity measurements you drew on the wall. Mark the stud locations with a pencil above the line on top of the vanity so you can see them with the vanity in place later. Measure the distance from the edges of the vanity measurements are pulled to the wall and gutters stub out and the water supply valves in the wall. Transferring these measurements on the back of the vanity. Cut access holes larger than the stub-out and supply valves with a drill and hole saws. For the new vanity in place against the wall, line up the outline on the wall with vanity. Place a level on the vanity, measured from front to back and side to side. The unit wood shims under the low-lying parts of vanity until it measures the level.

Control wood screws through the back of the wall mounted bathroom vanities. Use the marked stud locations to anchor the screws into the wall studs behind the vanity. Spreads a smooth bead of silicone caulk on the edge of the sink opening, and then lower the sink into the opening. Spread plumber putty on both sides of the tap is the deck plate. Place the deck plate over the faucet hole in the sink and then insert the tap through the deck plate and the holes in the sink. Wire nuts on the underside of the faucet, tightening the connections with basin wrench. Thread the water supply lines to the water supply valves and the underside of the faucet with a basin wrench. Wrap a rope of plumber’s putty around the underside of the drain assembly and then insert it through the drain in the sink. Tighten the nut compression on the bottom of the drain congregation, using a wrench. Wrap the pipe tape around all downspouts subjects beforehand tightening the pipe connections.

Incoming search terms:installed wall tile for bathroom photo with dimensions

Comments are closed.